HYDRAULIC CLAMPING CLYINDERS

  a.Threaded Body Cylinder

  b. Manifold Mounting Cylinder

  c. Hollow Piston Cylinder

  d. Pull Cylinder

  e. Swing Cylinder with overload    Protection

  f. Swing Cylinder without    overload Protection flange

  g. Swing Cylinder without    overload Protection flange

   h. Spring Clamp

  i. Compact Cylinder

  j. Block Cylinder

  K. Vertical swing cylinder

HOLLOW PISTON CLYINDER
SINGLE ACTING (SPRING RETURN), PUSH TYPE

Advantages:
Hollow piston cylinders can be easily adapted on existing fixtures. The cylinder can
be mounted on the stud, by increasing the stud length. Automation can be achieved
very fast.

Installation:
With the help of a back mounting plate, the hollow piston cylinder can be mounted on the
stud as shown in fig.1. The cylinder can also be used to pull the stud, by mounting it on the
other side of the base plate as shown in fig.2. For this arrangement, a wiper
should be provided to the stud for 10 mm stroke cylinders.

Manual Clamping	Figure 1	Figure 2

Specifications:

• Maximum oil pressure 200 bar.
• Return spring back pressure @ 1 bar.

Notes:

• As the cylinder is single acting, spring return, a breather is provided. It should be protected
  from cutting liquids and coolants.
• Cylinders with non-standard force and stroke can be made available on request.
• For ordering the seal kit, add the prefix "S" to the part number.
• Sealkit catalog details available on request .